In either case, don’t attempt to operate the grill until you’ve resolved the issue.ĭon’t forget to rinse all the fittings and connections after you’ve performed the leak test. If the leak is located at the regulator, turn off the gas and contact Weber’s customer service department. Return the fuel tank to the retailer who supplied it. If you spot the leak at the cylinder, then turn off the gas and disconnect the tank. However, if you do see bubbles, then you’ll need to take immediate action. If there aren’t any, then you don’t have a leak and the insufficient heat supply is caused by something else. Check the fittings and connections for soap bubbles. Slowly turn on the gas, twisting the tank valve counterclockwise. You can apply the solution with a spray bottle, a damp rag, or a regular scrubbing brush. Use this mixture to wet down the fittings on the regulator. To start, make a solution that’s about 1 part dish soap and 4 parts water. If so, feel free to skip ahead to Next Steps, below. You may have already taken this step when you first installed the gas tank, in which case you’ll be familiar with the procedure. If you suspect that the grill is in bypass mode, you should perform a leak test before doing anything else. In fact, depending on how low the gas flow is, the burners might not ignite at all. That means that the burners won’t be able to deliver the flames that you’ve come to expect from your Weber grill. When the regulator is in this bypass mode, the gas flow will be extremely low-around 10 percent of its usual volume, perhaps less. If you don’t follow the directions to the letter, the device is going to proceed as if you have a gas leak, which will restrict the flow from the tank. You’ll need to light the grill in a specific way to avoid “tripping” the safety device. The use of this safety feature has been mandated by the federal government to reduce the inherent risks of cooking over a gas flame. Since 1995, Weber has included a gas detection device inside all of its propane hoses or regulators. If the reset procedure doesn’t solve your Weber grill regulator problems, it might be because the grill has gone into bypass mode. Attempt to use the grill as you normally would. Make sure the valve is secure, then switch the tank valve back on. Pull the metal collar back toward the tank and insert the tip of the valve directly into the tank. Next, you’ll want to hook the regulator valve back up. When you’ve removed the valve, turn each burner knob to “HIGH” and wait for at least one minute, then switch them all off again. Take the regulator valve off the gas tank by pulling the metal collar toward the tank, then pulling the valve in the opposite direction. First, turn all the burner control knobs and the tank valve to their “OFF” positions. If the issue isn’t with the igniter system or the gas supply, a regulator reset could do the trick. Weber grill regulator problems can cause the burners to produce only a tiny glimmer of flame–or sometimes none at all. The regulator is the small segment of pipe that connects the grill to the gas supply. This complaint is usually caused by issues with the regulator. We would also recommend investing in a plastic spray bottle for applying the soap solution (see Performing a Leak Test, below). Check Price on Amazon Weber Grills Troubleshooting: Common Issuesīefore you begin, make sure you have a Phillips head screwdriver and a stiff-bristled brush on hand.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |